- RENISHAW AM400 machine characteristics :
- Build volume : ≈ 225 × 225 × 275 mm
- Laser 400W, λ = 1070 nm, 8kHz modulated, beam Ø 70 µm, Vmax 600mm/s.
- Possible materials : Ti6Al4V ELI, AlSi10Mg, 316L, tool steels, nickel alloys, cobalt-chrome alloys, NiTi, etc.
(we change material ≈ 5 times a year) - Powder spread by a soft silicone recoater.
- Argon atmosphere, with initial vacuum.
- Optional module for reduced build volume : ≈ 78 x 78 x 55 mm, for small-quantity tests (0.25 to 0.75 L of powder), without contaminating the machine circuits.
(for information, at the end of 2022, powder purchase costs were: 316L ≤ €100/kg, AlSi10Mg ≈ €100/kg, Ti6Al4V ≈ €500/kg) - Strengths :
- Inexpensive machine to buy.
- Very low gas consumption.
- Easy to clean when changing material, especially with the reduced build volume.
- Weaknesses :
- Less widespread than the long-established brands.
- 3D SYSTEMS ProX 300 machine characteristics
- Build volume : ≈ 250 x 250 x 250 mm
- Laser 500W, λ = 1070 nm,
- Printed materials : Stainless steels, tool steels, non-ferrous alloys, super alloys, Cermet (Al2O3; TiO2) and others.
(but we have always stayed with 316L) - Powder spread and compacted by a roller.
- Strengths :
- Can deposit powders that other machines cannot use (finer particle size, non-spherical).
- Powder compaction is possible and adjustable.
- Better roughness (finer powder and compaction).
- Lower self-supporting angles (≈30°).
- Weaknesses :
- High gas consumption.
- Difficult to clean when changing material.
- Laboratory capabilities (equipment list, in French) :
- Mechanical tests (hot/cold tensile, fatigue, uniaxial/biaxial)
- X-ray microtomography (RX Solutions 150 kV; measurable sample: 30 cm x 30 cm x 40 cm; best resolution, for a small sample: 5 µm; maximum penetration depths: stainless steel ≈10 mm, aluminium ≈100 mm, titanium ≈50 mm)
- Metrology, optical measurements, vibration measurements.
- Topography, morphology and structure of materials.
- Physical chemistry, corrosion, aging of materials.
- Tribology.
- Simulation software: Abaqus, Samcef, Patran/Nastran, Comsol, SDS, Fluent, Mecamaster, LMS, Catia V6.
- Software modules 01-ESI-AM-Modules.pdf, Heat Treatment ESI solution
- Demo build plate (upcoming ISO standard) :
CurrentArtifactDesigns.zip (file protected by password)

