Technical resources

  • RENISHAW AM400 machine characteristics  :Renishaw AM400 machine
    • Build volume : ≈ 225 × 225 × 275 mm
    • Laser 400W, λ = 1070 nm, 8kHz modulated, beam Ø 70 µm, Vmax 600mm/s.
    • Possible materials : Ti6Al4V ELI, AlSi10Mg, 316L, tool steels, nickel alloys, cobalt-chrome alloys, NiTi, etc.
      (we change material ≈ 5 times a year)
    • Powder spread by a soft silicone recoater.
    • Argon atmosphere, with initial vacuum.
    • Optional module for reduced build volume : ≈ 78 x 78 x 55 mm, for small-quantity tests (0.25 to 0.75 L of powder), without contaminating the machine circuits.
      (for information, at the end of 2022, powder purchase costs were: 316L ≤ €100/kg, AlSi10Mg ≈ €100/kg, Ti6Al4V ≈ €500/kg)
    • Strengths :
      • Inexpensive machine to buy.
      • Very low gas consumption.
      • Easy to clean when changing material, especially with the reduced build volume.
    • Weaknesses :
      • Less widespread than the long-established brands.
  • 3D SYSTEMS ProX 300 machine characteristics3D Systems ProX 300 machine
    • Build volume : ≈ 250 x 250 x 250 mm
    • Laser 500W, λ = 1070 nm,
    • Printed materials : Stainless steels, tool steels, non-ferrous alloys, super alloys, Cermet (Al2O3; TiO2) and others.
      (but we have always stayed with 316L)
    • Powder spread and compacted by a roller.
    • Strengths :
      • Can deposit powders that other machines cannot use (finer particle size, non-spherical).
      • Powder compaction is possible and adjustable.
      • Better roughness (finer powder and compaction).
      • Lower self-supporting angles (≈30°).
    • Weaknesses :
      • High gas consumption.
      • Difficult to clean when changing material.
  • Laboratory capabilities (equipment list, in French) :
    • Mechanical tests (hot/cold tensile, fatigue, uniaxial/biaxial)
    • X-ray microtomography (RX Solutions 150 kV; measurable sample: 30 cm x 30 cm x 40 cm; best resolution, for a small sample: 5 µm; maximum penetration depths: stainless steel ≈10 mm, aluminium ≈100 mm, titanium ≈50 mm)
    • Metrology, optical measurements, vibration measurements.
    • Topography, morphology and structure of materials.
    • Physical chemistry, corrosion, aging of materials.
    • Tribology.
  • Simulation software: Abaqus, Samcef, Patran/Nastran, Comsol, SDS, Fluent, Mecamaster, LMS, Catia V6.
  • Software modules 01-ESI-AM-Modules.pdf, Heat Treatment ESI solution
  • Demo build plate (upcoming ISO standard) :

CurrentArtifactDesigns.zip (file protected by password)

3D view of the demonstration artefact build plate3D view of the demonstration artefact build plate, second angle